View a Capcode - Pager

OVERVIEW

---

Pagers are used with the Paging Transmitter. Each pager has a unique code, called a "Capcode", to identify it. This is how the system is able to send a specific message to a specific pager.

This page explains how to View/Find the Capcode that has been programmed into the pager.

LAYOUT

---

The guide will refer to the buttons found on the front of the pager. Below is a layout of each button and the battery compartment.

1 - LCD (Readout) Screen.

2 - Right & Left Navigation Buttons.

3 - Function Button.

4 - Read (Power) Button.

5 - Battery Cover Lock.

6 - Battery Cover.

ADDITIONAL INFORMATION                       

   Setup Capcode    |    Add a Pager    

  Requirements  |  Transmitter Setup  

          Return to Administration         

INSTRUCTIONS

---

On the back side of the pager, unlock the Battery Cover by sliding the Lock in toward the center of the Cover.

---

Remove the Battery Cover.

---

Remove the AAA battery inside.

---

Press and Hold Down the "Function" (# 3 on the Layout) button.

---

Insert the AAA battery while Holding Down the "Function" button.

---

After a few seconds the LCD Screen will show a "Password". Press the "Read" (# 4 on the Layout) button One time.

---

The LCD Screen will now show the "Frequency" of the Pager. Press the "Read" (# 4 on the Layout) button One time.

---

The LCD Screen will now show the Capcode information. Make note of the Capcode.

---

Remove the AAA battery.

---

Insert the AAA battery - Do Not hold down any buttons.

---

Replace the Battery Cover.

---

Slide the Battery Cover Locks to the Outside.

---

The LCD Screen will show the pager home screen with the Date, Time and Battery Life.

---

Use the Capcode information to add it to a Contact in the VersaVision software.

ADDITIONAL INFORMATION                       

   Setup Capcode    |    Add a Pager    

  Requirements  |  Transmitter Setup  

          Return to Administration         

---