Coordinator - Check Status

OVERVIEW

After Installing the Linux Driver & Setting Up the connection in VersaVision, the Coordinator will begin to communicate with the other Mesh Devices.

When using multiple Coordinators with multiple Isolation Codes, the Mesh Device must be programmed to the SAME Isolation Code at the Coordinator.

A device on ISO Code 1 will only communicate with a Coordinator set to ISO Code 1. It will NOT communicate with the Coordinator set to any other ISO Code.

REQUIREMENTS

Computer/Server/VM must have either a Real Port Driver installed or a USB Coordinator plugged into the VC Server/Computer.

Coordinator must be setup in VersaVision under Administration - Mesh.

User will need to know if there are multiple Coordinators set up in VersaVision and the name of the Coordinator for the Status Check.

NAVIGATION

The Coordinator Status can be verified in Modules - Status.

This can be accessed via the Home Page menu or the Modules Icon. Once Modules has been selected - select Status from the menu.

---

USB Guides

Linux/RedHat Guides

---

INSTRUCTIONS

The Status screen will show all Mesh Devices that are communicating with the system.

The Network column is where the Coordinator Name can be found.

Verify that any Modules that have been programmed to the same ISO Code at the Coordinator, show in the list.

Each Module should have a Double Check Mark in the Status column.

Four our example(s), from the other instructions/steps, the new Coordinator was named "Building 2".

If your system has Mesh Devices communicating with the Coordinator, the installation is successful.

If you DO NOT see any Mesh Devices communicating wiht the Coordinator (image below), contact VersaCall Support for assistance.

---