IT - Coordinator Requirements
From VersaVision Support
Revision as of 17:04, 20 February 2024 by VVSupportAdmin (talk | contribs)
OVERVIEW
The information provided below is intended for the IT Department. This will provide basic information they may need to setup a Coordinator when VersaCall Hardware has been purchased.
GENERAL
VersaCall Hardware communicates with the VersaVision Server using a 900mhz mesh signal. A Coordinator is required to receive signals from the individual modules and to send commands to those modules.
- CLICK HERE for detailed information about the Mesh Signal/Network.
REQUIREMENTS
- 110v Power Outlet within 6 feet of placement/location.
- Ethernet Port within 6 feet of placement/location.
- Pre-Installed Static IP Address (VersaCall) or DHCP Reserved IP Address based on the MAC Address of the Coordinator (Customer IT).
- Outgoing Ports - Click Here for information about Ports related to a Remote Coordinator.
SPECIFICATIONS
- Dimensions – 3.5” (W) x 4.5” (L) x 1.5” (H)
- (1) 6’ Power Cord (included)
- (1) 6’ Ethernet Cord (included)
- (1) 7” Antenna (included)