Reporting - Data Filter Parameter
From VersaVision Support
Depending on how the Report was built, it may require the user to setup a Data Filter Parameter.
This parameter defines what specific Locations and/or specfic Monitoring Points.
This page will show and explain each option available for this type of Parameter.
 |
 |
|
By default the Tag Filter will not have anything selected - click on the Edit button to access the Tag Filter Builder.
- Click Here for instructions on setting up a Tag Filter in the Tag Filter Builder.
All tags that were selected in the Tag Filter Builder will show under the Tag Filter heading.
The Advanced mode can be enabled by turning the toggle on.
Once Advanced is enabled, a Filter field will load.
Advanced mode allows the user to type in tags and use the AND & OR commands between them. Select the Filter field to enter your tags with separators.
- AND - use this separator indicate that data is considered when an event has all the tags.
- OR - use this separator to indicate that either tag can be considered in the filter.
Example of a filter using the AND separator is in the image below.
Using this setup our report will only show data for events that have both the "location station 22" and "team lead" tags.
Any event that does not contain both of these tags will be omitted.
Example of a filter using the OR separator is in the image below.
Using this setup means our report will show data for any events that are tagged with "maintenance", "team lead" and "materials".
Any events NOT tagged with "maintenance", "team lead" and "materials will be omitted.
|
|
|
 |
|
|